Brushed Brush Speed Controller ESC/w Reverse for RC Car Truck Boat 1/8
1. This equipment used in electric model car,
and according to the following the information of choice scope
2. Automatically find the center.
3. High-frequency drive
4. The use of low-resistance field-effect inner tube
forward and backward functions for car, boat
6. Great budget speed control
upgrade from mechanical.
7. Electrical parameters: support: the nimh nickel
cadmium battery 4-6 group (4.8-7.2 V) The 8. Lithium battery 2 group
9. The move by lot current: forward 320 A reverse 240 A Brake 250A
1. The BEC output : 5.6V, 2A
Forward Current: 320A
3. Back Current: 240A
4. Voltage range :4.8-8 .4
5. PWM Frequency: 1.5KHZ
6. Size: 34 x 34 x 30 mm
7. Weight: 47g
1. Battery must be connected properly. at
both ends of wiring board, the red wire is positive, black is negative. (Or
connect to a standard DC battery plug.)
2. Turn on the power switch, if no
signal is input, this motor will issue a "beep-beep-beep" alarm sound. When
there is signal, the alarm sound stops.
3. Turn on the remote control, adjust
the trimmer to the middle(both red and green light goes out). Push forward the
throttle, the rc car will goes foward and the green light turns on. Then pull
back the throttle into the brake status. The greater the magnitude of the brake
pull back , the more tight it will be. Release the throttle to middle and pull
pack again, the red light turns on and the rc car goes backward
1. This product CANNOT be used
in humid environments.
2. Make sure the power is negative not reversed.
For brushed ESC of 320A or below, its plug current is always 1A
1 x 320A Brushed Brush Speed Controller
ESC RC Truck Car Boat Reverse 1/8 1/10